Lone Wolf Harp Octave Pedal
The Harp Octave is a great tool for the harp player who wants to have diverse sounds. It is a clean octave up generator in the sense that it has adds no solid state distortion; but what it does add are octave-up overtones that manifests itself in the midrange with a rasp that brings out whatever distortion is going on with the amp. The end result is a fuzz-crunchy-distortion that can be mild or intense, according to the settings chosen. This pedal is best when using the pucker, lip block and toungue block technique. If you've ever wanted your big amp to sound like a nasty little vintage Champ or Princeton, this is the pedal that'll do it. The effect will really cut through the mix and reduces feedback, you will get more volume out of your amp before feedback than ever before. The Harp Octave has a buffered input, true bypass, a Blend control and a Volume control. The Blend control increases or decreases the level of the generated octave and the Volume control allows you to have more control over your volume for solos and when playing into a pa. The buffered input provides the high impedance termination necessary to get the best tone form crystal, cm and cr elements; the output is also high impedance and plugs straight into your amp. The battery is switched off when an external power supply is used and the LED is on when the effect is in and is off when the effect is in bypass. The IN jack serves as the on/off switch so the pedal cannot be accidentally turned on and run your battery down. Plus; unlike guitar pedals, there is no loss of tone through the Harp Octave. The Harp Octave offers all of this and a money back guaranty if you are not satisfied for any reason.
Settings are very basic; when the Blend control is fully counterclockwise only the dry signal is heard and as you turn the control clockwise the octave will increase in level until it is at the same level as the dry signal. The Volume control sets you output level which does have a small amount of gain for increasing the your volume when desired. A 10 to 11 o'clock setting is great for a vintage amp distortion sound.
The pedal can be powered with a 9v battery or an ac adapter. The ac adapter requirements are a regulated 9V DC with a minimum 100mA output and a 2.1mm x 5.5mm connector with a negative center. The battery is switched off when an external power adapter is used and the "IN" jack acts as the pedal ON/OFF switch. Harp Elite offers power adapters for EURO customers and is sold seperately.
Eduardo G. published the 01/06/2022 following an order made on 23/05/2022
Anonymous A. published the 01/12/2020 following an order made on 16/11/2020
proprio conforme alla descrizione e alla altezza delle mie aspettative. Mi riesce a dare il suono che cercavo.
Anonymous A. published the 12/03/2020 following an order made on 08/03/2020
Sopresa! Non pensavo che facesse un suono del genere ...da avere assolutamente!
Anonymous A. published the 28/11/2019 following an order made on 24/11/2019
Awesome pedal and works perfect ..
You might also like
Customers who bought this product also bought:
Hohner MeisterKlasse MS
Reed Plate Set for Hohner...
Switchcraft Adapter 332AX -...
Hohner Marine Band Deluxe
16 other products in the same category:
Lone Wolf Harp Tone+
Lone Wolf Flat Cat Jason Ricci
- Online only